Magnavox 26MF301B Manuel de service télécharger pdf (Page 18)

5-2 FL11.3EA

1. Purity Check Mode

This mode cycles through full-screen displays of red,

green, blue, and white to check for non-active pixels.

1. Enter the Service mode.

2. Each time the [7] button on the remote control unit

is pressed, the display changes as follows.

3. To cancel or to exit from the Purity Check Mode,

press [CH RETURN] or [PREV CH] button.

2. VCOM Adjustment

1. Operate the unit for more than 60 minutes.

2. Set the color analyzer at the zero point calibration

and bring the optical receptor pointing at the

center of the LCD-Panel at a distance of 1.18

inches(3cm) away from the LCD-Panel surface.

Note: The optical receptor must be set

perpendicularly to the LCD Panel surface.

3. Enter the Service mode.

4. Press [3] button on the remote control unit.

5. Press [CH X/Y] buttons on the remote control unit

so that the color analyzer value becomes

minimum.

6. To cancel or to exit from the VCOM Adjustment,

press [CH RETURN] or [PREV CH] button.

[7] button

Note:

When entering this mode, the default setting is White mode.

Purity Check Mode

[7] button

Red mode

Green mode

Blue mode

Black mode

[7] button

White mode

[7] button

White 20% mode

[7] button

Test Point Adj. Point

Screen

[CH X/Y ]

buttons

M. EQ. Spec.

Color analyzer See below

Figure

Color Analyzer

To avoid interference from ambient

light, this adjustment should be

performed in a dark room.

L = 1.18 inches

Perpendicularity

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 69 70

Commentaires sur ces manuels

Pas de commentaire

Magnavox 26MF301B Manuel de service Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour TV LCD Magnavox 26MF301B